Loading... Please wait...
Categories
New Products
-
$10.00 -
$350.00 -
$225.00 -
$510.00 -
$29.00
- Home
- Wind Data Collection
- Lightning arrestor, with DIN rail clips
- Home
- Wind Data Collection
- Sensors
- Lightning arrestor, with DIN rail clips
Product Description
Lightning arrestor, DIN rail mountable
This is the DIN rail mountable version of the lightning arrestor designed by APRS World, LLC. This is designed as an add on to a Data Logging system for areas of high lightning risk. It protects signal lines from the anemometer and all other sensor signal lines going into the data logger. Includes feet and screws for attaching to standard 35 mm (1.4 in) DIN rail. A #2 phillips (+) screwdriver is required to assemble. DIN rail not included.
Does not come with DIN feet attached. Assembly required.
Note: Proper grounding is essential for lightning protection. The board will not provide any protection without a solid ground connection.
Product Videos
How to Attach DIN Clips (00:48)
This short tutorial will show you how to attach your APRS World breakout board to a DIN rail, using our DIN rail mounting clip kit.
First, attach the two DIN clips by hooking the rounded bottom portion of the clip around the rail (slight pause in video) and then pushing down on the other end to snap it into place. Line up the breakout board (slight pause in video) with the already placed clip to estimate the spacing for the second one.
After attaching both clips, place the breakout board on top and line up the holes, adjusting width as needed.
Using your #2 phillips screwdriver, tightly screw the breakout board onto the clips. Make sure the holes remain aligned as you do this.
And you’re finished. Your breakout board is now mounted onto the DIN rail.
For more products and information visit www.aprsworld.com
-
How to Attach ...This short tutorial will show you how to attach your APRS Worl...
